This package includes the stereo, a wired remote control and 12 foot cable.
This unit does not have a CD player! Instead, the faceplate flips down to reveal a protected storage area for your iPod or iPhone. A 30 pin adapter inside connects your Apple device and allows it to be recharged and controlled while inside the stereo. (a 30 pin to lightning adapter may be required for newer iPhones)
The stereo is 2 zone capable which means volume and audio source can be controlled independently in 2 different areas. For example, listen to FM radio on deck while others listen to iPod in the cabin. The built in amplifier will power up to 8 speakers 4 in each zone.
The IP-3B controls your iPod with full navigation of all menus and is equipped with 2 auxiliary inputs for other MP3 players as well. The 4 X 50 watt amplifier delivers power to spare. The IP66 rating ensures protection against water, dust salt/fog and UV. Unlike other re-purposed car stereos that oxidize in moist environments, the IP-3B has a ZAM-coated Steel Chassis to protect from corrosion. The conformal-coated circuit boards also have silicone added in critical areas to protect them from moisture. The mechanism meets commercial grade specifications of -20 deg. C to 70 deg. C. most other third-party units only meet -10 deg. C to 60 C degrees. The player features an LCD Dot Matrix display with 2-stage dimmer control, RCA inputs and 4-volt outputs. This unit includes a DSP Digital Sound Processor as well as sub-woofer output control. AQ-IP-3B is equipped with two 12-volt triggers on/off and four 5-volt triggers that are momentary and the FM tuner has USA/Euro switchable frequency.
308 watts total peak power 47 watts per channel @ 4 ohms 4 x 47 watts 77 watts per channel @ 2 ohms 4 x 77 watts Dual Zone Operation control volume and source independently in 2 different areas 4 Position Dimmer Plug and Play Subwoofer Output for sending an independently controlled signal to a subwoofer Wired and Wireless RF Remote Ready remotes sold separately Switchable USA/Euro 6 AM Presets 18 FM Presets FM-1, FM-2 FM-3 Full iPod and iPhone Control 2 RCA Aux inputs for MP3 players or other external sound sources Sealed Stainless Steel Chassis Dot Matrix Low Heat Read Out Bass/Treble Balance Fader Multi-Environment Certifications For Durability IP66 Exposed Faceplate Area CFR46 Compliant ASTM117 Salt Fog Compliant ASTM D4329 UV Ultraviolet Compliant Faceplate Seal Included waterproof wired remote AQ-WR-3F with cable requires a 2 1/8 cutout
Dimensions Din Size 1 Chassis Size W 7.25" 184mm Chassis Size H 2.0" 51mm Chassis Size D 7.38" 178mm Faceplate Size W 8.50" 216mm Faceplate Size H 2.75" 70mm Faceplate Size D 1.75" 44mm
A great unit to use on a aftermarket fairing or Harley stock fairing.
Submitted 2015-06-13 by Lake life, Tennessee
iPod control is flawless put a 30 to lightning adapter on it for my iPod 5,wish I could turn the dsp off it messes with my crossover but finally got it tuned right,don't be fooled by the high powered amp will push lower grade speakers,hook up a amp and sub and it shines well built receiver ,had a over sized face won't fit in single din opening
Retailers comment: The chassis will fit in a single DIN opening, but the faceplate is larger and overlaps. You will want to check the measurements in the description before you purchase.
Submitted 2013-08-02 by KNIGHT, Colorado Springs
I should say up front that I had this installed on a motorcycle. The stereo sound and volume seems lower when using the XM radio. Regular radio and IPod sound fine. Biggest issue is the plastic piece that holds the faceplate in place. This is supposed to fully release the faceplate when depressed. This plastic piece broke in less than a year of use.
Submitted 2015-07-25 by metki, knoxville tn
this is a very low grade radio I have it hooked to very high priced speakers and amp and it sounds bad replaced it with a name brand and have a top notch stereo ,don't waste your money,and the wattage they quote is max it puts out 15 watts rms a channel ,boat anchor quality