Pioneer GM-ME600X6 6 Channel 1200 Watt Marine Amplifier

Description

Click here to download the product manual or factory spec sheet

Power up to 12 speakers (wired in parallel) or 8 speakers and a subwoofer with this digital 6 channel marine amp.

• Conformal coated circuit boards prevent corrosion in a marine environment
• 1200 watts total peak power (estimate)
• 75 watts RMS (continuous) power x 6 channels at 4 ohms
• 100 watts RMS (continuous) power x 6 channels at 2 ohms
• 200 watts RMS (continuous) power x 3 channels bridged
• Frequency Response – 10 – 50K Hz
• Signal-to-Noise Ratio – 75dB
• Matched Power Ratings for optimal use with Pioneer Marine Speakers and Subwoofers
• Rubber covers protect side panel controls, RCA terminals, and fuses
• Preamp and speaker-level inputs
• Corrosion-resistant chassis design
• SAE J1171 Certified (Ignition protection) ABYC/NMMA Compliant Terminal Connections
• 21-step frequency selection (LPF/HPF)
• Switching power supply controlled by microcomputer
• Dimensions (L x W x H) – 7-1/8″ x 10-1/4″ x 2-1/16″
• Built in crossover for sending the correct frequencies to subwoofers and other speakers
• 1 year manufacturer warranty

It takes a lot of amplifier power for your music to be heard clearly over the sounds of the waves, wind, and engine noise. Pioneers ME-Series GM-ME600X6 six-channel marine amplifier can put out up to 100 watts RMS per channel, enough for everyone in and around your boat to hear the music. You could bridge a couple channels together to power a sub with up to 200 watts RMS while sending four speakers 100 watts each. You could also use this amp in 3-channel bridged mode to power a trio of high-performance loudspeakers with up to 200 watts RMS each. The GM-ME600X6 can be switched between high power and normal modes, so you can match the power level to your speakers or your volume preferences.